|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,051 Points: -13,308
|
Phillips size 00, 0, 1 & 2 Screwdrivers. (Be aware that the tip sizes can vary).
Small flat-bladed screwdriver for adjusting the carburettor.
Modelling knife.
Needle nose pliers.
Side cutters.
Scissors.
Metal rule.
You will receive allen key (hex) wrenches where needed during the series.
A cross wrench is provided at stage 8.
Take great care to identify the correct Screw type and length of screw required for each build stage.
You will require a good quality 'thread locking' fluid.
Differential grease is provided in the collection, however you may wish to consider using an 'anti-fling' heavy duty type, such as "Hpi Z164 heavy duty" grease.
|
|
|
 Rank: Beginner Level 3  Groups: Registered
Joined: 06/12/2013 Posts: 23 Points: 69 Location: London
|
Hi all Can anyone tell me if I went the hpi z164 route how much I will need as they seem very small tube 6g Thanks 
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,051 Points: -13,308
|
Three tubes should be enough, one each for the front and rear diff's and another for geared reduction hubs, though you might want to invest in four and keep one for servicing etc
|
|
|
Rank: Beginner Level 3 Groups: Registered
Joined: 06/12/2013 Posts: 23 Points: 69 Location: London
|
Thank you MrT 
|
|
|
 Rank: Newbie Groups: Registered
Joined: 25/07/2014 Posts: 3 Points: -1
|
Hi Mr. T thanks for that.
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
